Throttle Relearn Instructions for Throttle Body (TB)

Follow these steps to complete a Throttle Relearn:

  1. Disconnect the negative battery terminal for 5 minutes. Then reconnect it.
    NOTE: If this is a new install, proceed to step 2.
  2. Turn ignition key to on position, do not start the engine.
  3. Slowly depress the gas pedal to the floor, and then slowly release it. Do this three (3) times. On the third press hold the pedal down to the floor for approximately 10 seconds or until check engine light starts flashing, once the check engine light starts to flash u can release the gas pedal then wait for the engine light to stop flashing and Turn the key off.
  4. Now start engine. The gas pedal is now in synch with the larger throttle body.